There are tabs to latch it where? Are you assuming I am using a Ubiquiti dish? These are Radiowaves dishes (2 ft at one end, 3 ft at the other) that are already on the tower.
Should I be looking at something like this? http://www.balticnetworks.com/rf-elements-easybracket-s-brocket-wall-pole-mount-for-ubiquiti-rockets-and-unifi-outdoor-series.html From: Josh Luthman Sent: Tuesday, July 07, 2015 4:01 PM To: [email protected] Subject: Re: [AFMUG] mounting AF5X to tower (non UBNT dish) Jeremy put it right on the dish. There are tabs to latch it, but I like his idea of only using the two and longer jumpers. This leaves room for the GPS connector. Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373 On Jul 7, 2015 4:54 PM, "Ken Hohhof" <[email protected]> wrote: What have people been doing to mount the AF5X radio when using a generic, non Ubiquiti dish? So there is no Rocket bracket to clip it to? In this case I am replacing some old Trango 5010 PTP radios and using the existing Radiowaves dishes. There's a place on the back of the radio that you could pass a hoseclamp through, but that doesn't seem right, especially since the ground screw sticks out too far for that to work well. Photos anyone?
