On Fri, 2015-07-17 at 22:23 +0000, TJ Trout wrote:
> I have a set of Mimosa radios that when installed 3 weeks ago 
> reported 500mbps mac rate and that was confirmed with the radios 
> internal speed test as well as btest between two CCR's in both TCP 
> and UDP, everything was great until I upgraded to beta software and I 
> started seeing a problem where the radios Phy/Mac/Speed test are all 
> the same as prior but when doing btest between two CCR's I can get 
> 500 udp but only about 5-40 tcp!
> 
> I promptly downgraded software and I'm still seeing the same problem.
> 
> Any ideas?

The most common cause of this sort of symptom is a speed/duplex
mismatch on an ethernet port.  Check them all (both sides of each link)
until you verify this is not the issue.

-- 
Butch Evans
Training and Support for WISPs
702-537-0979
http://store.wispgear.net/
http://www.butchevans.com/

Reply via email to