Ah, but the power levels on the status and statistics page show combined. Therefore the SSR could be showing one channel way off.
Is there anywhere in a PTP650 to see V and H power levels separate? Adam From: Af [mailto:[email protected]] On Behalf Of George Skorup Sent: Wednesday, September 09, 2015 11:56 AM To: [email protected] Subject: Re: [AFMUG] PTP650 Issue That's very confusing. If all of the power levels are nearly the same, how can the ratio be that far off? That makes no sense. Unless it doesn't mean the same thing as with SSR on the PMP450 (V-H or B-A Rx power ratio). On 9/9/2015 11:01 AM, Josh Luthman wrote: I was thinking signal vs noise. Like SNR. Seems impressive to know there's a cable issue when the signals are the same. Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373 On Sep 9, 2015 11:55 AM, "SmarterBroadband" <[email protected]> wrote: Just a noise issue? The manual says; Signal Strength Ratio is an aid to debugging a link. If it has a large positive or negative value then investigate the following potential problems: • An antenna coaxial lead may be disconnected. • When spatial diversity is employed, the antenna with the lower value may be pointing in the wrong direction. • When a dual polar antenna is deployed, the antenna may be directed using a side lobe rather than the main lobe. I was thinking bad cable? Maybe antenna or radio. From: Af [mailto:[email protected]] On Behalf Of Josh Luthman Sent: Wednesday, September 09, 2015 8:40 AM To: [email protected] Subject: Re: [AFMUG] PTP650 Issue Noise at the one end. The other has 20 with the same signal. Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373 On Sep 9, 2015 11:36 AM, "SmarterBroadband" <[email protected]> wrote: We have an issue with one of our PTP650 links. Bad Signal Strength Ratio. One end is 6.4 the other 19.5 Issue is probably at one end. Question is which end to check first. I have attached the System Stats of each end. Anyone able to see which end may have the problem from these? Thanks Adam
