It sounds right conceptually. I'll be curious to learn whether that
fixes your problem.
On 10/30/2015 10:06 AM, Sterling Jacobson wrote:
Oh, so I create two VLAN interfaces, both with the same VLAN ID?
I assign those to their respective interfaces (or bridges?) and then
create a new bridge and put both the VLAN interfaces in THAT bridge?
*From:*Af [mailto:[email protected]] *On Behalf Of
*[email protected]
*Sent:* Friday, October 16, 2015 8:52 AM
*To:* [email protected]
*Subject:* Re: [AFMUG] Anyone seen this, Mikrotik VLAN leakage of
Neighborhood protocol?
You should only be bridging the VLANs. So, put a VLAN on both
Interfaces and then just bridge the VLANs.
On Fri, Oct 16, 2015 at 10:42 AM, Sterling Jacobson
<[email protected] <mailto:[email protected]>> wrote:
When I assign a VLAN to an interface and bridge it to another
interface/bridge, I can suddenly see devices on the 'other' side
in Neighborhood view.
Is this a bug?
In my mind that should not be happening.
And if it's leaking Neighborhood protocols, what else is it leaking?
I does separate layer 3 traffic/IP just fine like it should.
