Get it off channel 7. Poke around at the sub end and see what else is on what channel. Typically, there will be less noise at channel 1 or 11. Most SOHO routers are going to be on channel 6, and putting your stuff on 7 will get local interference most of the time.

bp
<part15sbs{at}gmail{dot}com>

On 11/14/2015 1:34 PM, Tim Reichhart wrote:
Josh
these stats are at the CPE and I even have the rf shields on the AP's and the ap's are up 150ft up the air. So it sounds like I am going have to probably switch it to 5ghz.

Tim

    ------------------------------------------------------------------------
    -----Original Message-----
    From: "Josh Luthman" <[email protected]>
    To: [email protected]
    Date: 11/14/15 04:28 PM
    Subject: Re: [AFMUG] link problems

    Looks like noise at the AP being my first thought. Assuming those
    stats are from the CPE.

    Josh Luthman
    Office: 937-552-2340937-552-2340
    Direct: 937-552-2343937-552-2343
    1100 Wayne St
    Suite 1337
    Troy, OH 45373

    On Nov 14, 2015 4:27 PM, "Tim Reichhart"
    <[email protected]
    <mailto:[email protected]>> wrote:

        The customer is wanting 8 meg but is only getting 3-4 meg
        there josh

            
------------------------------------------------------------------------
            -----Original Message-----
            From: "Josh Luthman" <[email protected]
            <mailto:[email protected]>>
            To: [email protected] <mailto:[email protected]>
            Date: 11/14/15 04:25 PM
            Subject: Re: [AFMUG] link problems

            What's the problem..?

            Josh Luthman
            Office: 937-552-2340 <http://tel:937-552-2340>937-552-2340
            <http://tel:937-552-2340>
            Direct: 937-552-2343 <http://tel:937-552-2343>937-552-2343
            <http://tel:937-552-2343>
            1100 Wayne St
            Suite 1337
            Troy, OH 45373

            On Nov 14, 2015 4:20 PM, "Tim Reichhart"
            <[email protected]
            <mailto:[email protected]>> wrote:

                Hello Guys
                I just installed an powerbeam m2 today at customers
                house and I am getting:

                signal strength -61 dBm
                noise floor -89 dBm
                transmit CCQ 86.4%
                tx/rx rate is around 10-39mpbs/58.5-65mbps
                Channel width 10MHz
                Channel/Frequency 7/2442MHz
                Version v5.6.2 (XW)
                from the tower to CPE is around 3.5miles





        Call
        Send SMS
        Call from mobile
        Add to Skype
        You'll need Skype CreditFree via Skype

Call
Send SMS
Call from mobile
Add to Skype
You'll need Skype CreditFree via Skype

Reply via email to