Thats more than enough for most SCADA applications On Dec 15, 2015 6:33 PM, "Ken Hohhof" <[email protected]> wrote:
> Had to go to 5 MHz channel to stay registered, 1X MIMO-A, about 2 Mbps > aggregate throughput on linktests. That's useless. > > I can't say I'm all that surprised, the signals are bad and the > interference is worse. But the only way to find out was to try it. > > > -----Original Message----- From: George Skorup > Sent: Tuesday, December 15, 2015 7:25 PM > To: [email protected] > Subject: Re: [AFMUG] 900 MHz 450i report > > So what did you get, about 10dB SNR and 5Mbps of throughput? > > On 12/15/2015 7:19 PM, Ken Hohhof wrote: > >> We swapped out an FSK AP in a high interference area today. No magic, >> works about the same. >> >> Too bad, even the installer liked the SM and antenna. Even the coax >> boots are nice. >> >> Will probably work well for those of you who don't have -65 noise floors. >> >> We are going to have to give up on 900 MHz at this location. This was >> the last gasp. >> >> > >
