Yeah that is exactly how I have done it in the past. I do recommend
upgrading. Vlans and PPOE I found were unreliable up until v12
On 4/6/2016 11:06 PM, George Skorup wrote:
Enable VLAN on the AP, save and reboot. Set Default Port VID to the
desired VLAN ID# on the SM(s), save and reboot. That should put the
PPPoE/NAT interface on that VID. I haven't messed with NAT and VLANs on
Canopy though.
The AP with VLAN enabled basically becomes a VLAN trunking device. So
you need to handle that on your switch or router. Switchport mode trunk,
encapsulation dot1q, etc. MikroTik... add VLAN sub-interfaces.
Oh, and 11.2, so this is PMP100? I would strongly advise you to get up
to 13.4.1. I've been running it for about a month on a couple sites and
two weeks on the rest of the FSK network and it has been stable. I think
I might have lost the additional color codes on some SMs, but really no
more issues than that.
On 4/6/2016 9:50 PM, heith wrote:
Hello,
�
I need some configuration help on Cambium. We are wanting to configure
the Canopy subscriber module (v11.2) to be the PPPoE client and NAT
the customer's traffic from the Ethernet port. This works fine, of
course, but we need the PPPoE to be on a tagged VLAN and we're. Not
quite sure how to configure the VLANs in the AP and the SM so the SM
will use the tagged VLAN for the PPPoE. Anyone done this?
�
Thanks
Heith
Celerity Broadband
