I think I found the answer… I enabled “Routing Mode” on the port and the IP started pinging.
I can no longer make this interface untagged for a given VLAN though… Wish there was a way to do both… From: Af [mailto:[email protected]] On Behalf Of Justin Marshall Sent: Tuesday, April 12, 2016 10:05 AM To: [email protected] Subject: Re: [AFMUG] EdgePoint S16 Actually looking at the CLI right now just to make sure I didn’t miss anything… Haven’t found anything yet though Thanks! From: Af [mailto:[email protected]] On Behalf Of Josh Reynolds Sent: Tuesday, April 12, 2016 10:03 AM To: [email protected]<mailto:[email protected]> Subject: Re: [AFMUG] EdgePoint S16 Side note, have you looked at the manual? It's quite good. I did all my config via CLI, so there's something I might have done in there at the time that may not be available in the GUI - I don't know. On Apr 12, 2016 8:56 AM, "Josh Reynolds" <[email protected]<mailto:[email protected]>> wrote: Something is off in your config somewhere. I've got some meetings this morning, but I should be back to the NOC before noon. I've got 6 edgeswitches of various shapes and sizes in one of our racks, so I'll try it when I get back in to see if I can help you figure out your issue. On Apr 12, 2016 8:49 AM, "Justin Marshall" <[email protected]<mailto:[email protected]>> wrote: Tried that too… Still can’t ping it From: Af [mailto:[email protected]<mailto:[email protected]>] On Behalf Of Josh Reynolds Sent: Tuesday, April 12, 2016 9:46 AM To: [email protected]<mailto:[email protected]> Subject: Re: [AFMUG] EdgePoint S16 Make sure it's got an untagged vlan assigned to it On Apr 12, 2016 8:43 AM, "Justin Marshall" <[email protected]<mailto:[email protected]>> wrote: Hi, I have an Edgepoint S16, and have an IP address assigned directly on one of the interfaces done through Routing->IP->Interface Configuration. However, I am unable to reach that IP when directly connected to that interface through a laptop. I can still reach the IP Address assigned under System->Connectivity->IPv4. I need to be able to reach the interfaces directly through IP addresses assigned only to those interfaces. What am I missing here? Tried excluding the port from the default VLAN just to see if that would make a difference, but ultimately will not be able to do that once it’s deployed anyways… Thanks
