The EdgePoint is wasting my attention span. ;-)
----- Mike Hammett Intelligent Computing Solutions Midwest Internet Exchange The Brothers WISP ----- Original Message ----- From: "Josh Reynolds" <[email protected]> To: [email protected] Sent: Tuesday, June 28, 2016 11:01:55 AM Subject: Re: [AFMUG] Mikrotik Bridging VLans Yo be fair, you're pretty much wasting many of the capabilities of the edgepoint, but you can do it that way if you want, or use Mike's suggestion. On Jun 28, 2016 10:52 AM, "Nate Burke" < [email protected] > wrote: Ok, so I'm hearing "the way you're doing it is wrong" Is there a better way? Or just let the R6 act as a dumb switch, and then log into that to try to troubleshoot any per port issues. On 6/28/2016 10:49 AM, Josh Reynolds wrote: <blockquote> I think you have a fundamental misunderstanding of the purpose of vlans... On Jun 28, 2016 10:48 AM, "Nate Burke" < [email protected] > wrote: <blockquote> Then how do I get all the Ports on the Edgepoint to share the same IP Space? On 6/28/2016 10:45 AM, Mike Hammett wrote: <blockquote> *nods* just leave the VLANs as native interfaces on the Mikrotik. No need to bridge them. ----- Mike Hammett Intelligent Computing Solutions Midwest Internet Exchange The Brothers WISP From: "Josh Reynolds" <[email protected]> To: [email protected] Sent: Tuesday, June 28, 2016 10:44:28 AM Subject: Re: [AFMUG] Mikrotik Bridging VLans It doesn't like that you're bridging all these vlans. From experience, it's nothing but broken-ness. You can still torch each vlan interface you know. On Jun 28, 2016 10:42 AM, "Nate Burke" < [email protected] > wrote: <blockquote> I'm working on the bench with a UBNT Edgepoint (R6 model) The newest firmware allows you to set per port untagged Vlans in switch mode. I'm thinking of using this to power a cluster of AP's, but I'd like to keep the ability to view per port traffic in the mikrotik via Torch for monitoring/troubleshooting purposes. My Plan was to put each port on the R6 on a different Vlan, Have a Trunk port to the mikrotik, then just bridge the Vlans together in the Mikrotik. This mostly works, as the Mikrotik can talk to each AP, but the AP's cannot ping each other, and it seems that I have random packet loss from the Mikrotik to the AP's. Is there a setting I'm missing that's blocking the traffic between Vlans, or is this a Edgepoint problem? Or does it not like that I'm bridging all these Vlans that are on the same Mikrotik interface. </blockquote> </blockquote> </blockquote> </blockquote>
