Raise the cost of path A on both ends of the hop.
------ Original Message ------
From: "Christopher Gray" <[email protected]>
To: [email protected]
Sent: 8/8/2016 4:43:30 PM
Subject: [AFMUG] Control VPLS Path in Mikrotik?
I'm running basic MPLS over OSPF in a section of my network.
I just setup a VPLS that has two path options:
A: 1 hop; limited to 20 Mbps
B: 2 hops; limited to 100 Mbps
The system favors A (I believe since it is only 1 hop, but it is also
lower cost in OSPF). Is there an easy way to send a VPLS over an
alternate path (path B in my case) without setting up RSVP and Traffic
Engineering everywhere? Will modifying OSPF path cost help?
Thank you - Chris
--------------------------------------------------------------------------------
