One other random idea....bring your own known good laptop the customer
prem just to make sure it isn't their equipment. Maybe you've done that
already.
------ Original Message ------
From: "Jordan Gregory" <[email protected]>
To: [email protected]
Sent: 8/18/2016 11:34:26 PM
Subject: Re: [AFMUG] New to list - issues (i think) with ePMP 2.4
Everyone,
I enabled the MIR profiles and set the one I am talking about to
25000/5000, the link test shows this speed perfectly, except when we do
a speedtest via speedof.me or speedtest.net or anything really, it's
only showing 3Mbps.
I have a cambium support ticket open, but that may take a while.
I've dug through every setting I can find and can't see anything that
would be causing this.
Here is the generic layout of my network:
SM --><-- AP --> L3 Switch --> BH Radio --> <-- BH Radio --> Switch -->
Router --> Internet
I've tested the speed (iperf) all the way from my router to my l3
swtich at the tower and I'm getting roughtly 750Mbps avg to the l3
switch. I've tested throughput on the switch as well and I was easily
passing 5Gbps through it.
I've seen no speed mismatch errors anywhere on the network.
Thank You,
Jordan Gregory
Founder / CEO
Hive Wireless, LLC
On Thu, Aug 18, 2016 at 11:05 AM, Kerry <[email protected]> wrote:
Here's a couple things to check,
Check the ap, is MIR under QOS enabled? if so, there should be an
entry under monitor->wireless for the sm showing the rate the sm is
'queued' at.
The wireless link test will only show it passing roughly what it is
queued at. Also, check the MCS column. If it;s a good link it will be
at the max Rate setting configured
under the radio config of the ap
On 8/18/2016 11:46 AM, Jordan Gregory wrote:
Good day list,
I have a Force 200 operating at very good signal levels but for some
reason, I can seem to get any more than 3Mbps out of the connection.
Did i miss a setting somewhere?
Backstory: Brand new wisp
Thank You,
Jordan Gregory
Founder / CEO
Hive Wireless, LLC
