That sounds like massive OOB to me.

bp
<part15sbs{at}gmail{dot}com>

On 8/23/2016 5:03 AM, [email protected] wrote:
STRONG 900MHz interference will kill the GPS signals on the ePMP, PMP, Packetflux and Ubnt. I have two sites where only the ePMP 2000 GPS works (and works awesome). One is a FM tower with a licensed 900MHz feed about 30 ft away and the other is the power company with 900MHz omnis blasting away.

I haven't tried the ePMP 2000 without the sector to enclose the GPS puck so I don't know if is the way they are
shielding the puck or the cable.

On Tue, Aug 23, 2016 at 7:43 AM, That One Guy /sarcasm <[email protected] <mailto:[email protected]>> wrote:

    Pokemon go is absorbing all the GPS signals. It's a Chinese conspiracy


    On Aug 22, 2016 8:34 PM, "George Skorup" <[email protected]
    <mailto:[email protected]>> wrote:

        I have seen the SyncPipes do exactly the same thing. Sats
        visible, but none tracked. A power-cycle will usually bring
        them right back. They just seem to get confused once in a while.

        I have one very problematic site. We've tried swapping pipes,
        cables, everything. It just goes stupid. At times even no
        visible sats. Power-cycle it and it will see 10+ visible, but
        still can't get lock. A couple more power-cycles will bring it
        back. And then it might go nuts again an hour or two later.
        Then it's perfectly happy for weeks. I don't get it. This is
        at a grain leg where we're in the process of moving between
        legs. The new leg is across the street about 500 feet. That
        one has a SyncInjector and pipe on the ground with metal all
        around and it works perfectly fine. Splain me that. In fact, I
        pretty much never have these issues with pipes attached to
        SyncInjectors. I have a site that has been running for 444
        days and the 1PPS event counter on that injector is at... 1.

        On 8/22/2016 5:20 PM, Nate Burke wrote:
        We've been running EPMP For a well over a year now.  I have
        not made any firmware changes in a while, everything is on
        2.6.1, but last week I had 2-3 sectors (not all sectors at
        the site) at 2 sites separated by 20+ miles that started
        having sync problems to the point where I had to set them to
        generate sync.  Is it just isolated to me, or is something
going on with the GPS Sky thingies that is affecting EPMP? All radios are using the included GPS Antennas, and have been
        installed for several months.  I'll see either all satellites
        disappear from the monitor->GPS page, or it will show
        satellites as visible but not tracked with an SNR of 0.  I
        have tried both Software reboot, as well as powercycle, and
        they're are still acting this way.

I've included the graphs for 3 sectors at the same site. Blue is visible satellites, green is Tracked Satellites. You
        can see the NW Sector has visible, but is losing tracking.
        These were all working fine until last week.





Reply via email to