We use PV2632 from perfect-10.tv and cut it into strips and apply it to the bottom of the mast. We have a technique to keep it from twisting up.
On Wed, Sep 14, 2016 at 4:55 PM, That One Guy /sarcasm < [email protected]> wrote: > We just put lags through the plate and a small wrap of mastic, sucks down > and seals withoum creating a dam > > On Sep 14, 2016 10:42 AM, "Chuck McCown" <[email protected]> wrote: > >> Short piece of steel schedule 40 tubing beveled on one end makes a great >> cookie cutter for bolt holes. >> >> *From:* Ken Hohhof <[email protected]> >> *Sent:* Wednesday, September 14, 2016 9:24 AM >> *To:* [email protected] >> *Subject:* Re: [AFMUG] Tar Tape Sealent >> >> Another name is “pitch pad”. But rather than buy little pads, I just use >> butyl mastic tape, like 3M 2229 in 3 inch width, and cover the whole bottom >> of the J-arm base. I also find it helps if you use some sort of tool to >> cut out a hole where the lags go through, to prevent the lags from grabbing >> onto the tape and trying to twist it into a knot. >> >> >> *From:* Jaime Solorza <[email protected]> >> *Sent:* Wednesday, September 14, 2016 10:17 AM >> *To:* Animal Farm <[email protected]> >> *Subject:* Re: [AFMUG] Tar Tape Sealent >> >> >> Ronard sells it I believe >> >> On Sep 14, 2016 9:12 AM, "Matt" <[email protected]> wrote: >> >>> Looking for a source of tar tape. The type to put under j-arm mount >>> to seal holes when putting on a shingled roof. >>> >>
