I can't remember the plug type, but I got 10 of them so if u want one or two send me your address. Depending on the age of your CCR1036 it's either : 1. two connectors, ready for redundant second psu, 2. one connector, needs second connector installed. 3. One connector, second connector is not connected to board/missing voltage regulator.
I think they are 14-30v, you can just wire a pigtail from the board connector to a 2.1x5.5mm jack that you panel mount in the back of the router, then use a male 2.1x5.5 to go to your DC plant. If you want redundant with the onboard AC use two 10a rectifier diodes in series with the positive side of the two power sources. On Wed, Nov 16, 2016 at 9:24 AM, Gilbert T. Gutierrez, Jr. < mailing-li...@phxinternet.com> wrote: > Has anyone powered one of these routers via DC (not PoE)? It looks like > the board supports 2 power ports on the board (setup for dual power) and I > want to make sure I have redundant power which I can do via DC. I need to > determine the plug and the voltage. > > Gilbert > >
