Nate, For testing purposes.... Considering using the Traffic Generator vs the BW Test tool. (look at the MT wiki for instructions). With CCR1009, pay attention to which ports you are connecting to.. due to the switch chip in there, not all ports have 1g connection to the CPU.
Avoid, bridge ports, change the default interface queue to ethernet-defaut you can also get more information out of the AF24, by connecting to them via ssh/telnet and issuing emacstat command.. I am not sure about the Edgepoint or 16SG, if they provide enhanced ethernet stats. (We like the netonix cause they show a lot more details of ethernet stats, the MT will also do that when you look at the ethernet stats via CLI) All of these should be able to help you find the issue. Regards. Faisal Imtiaz Snappy Internet & Telecom 7266 SW 48 Street Miami, FL 33155 Tel: 305 663 5518 x 232 Help-desk: (305)663-5518 Option 2 or Email: [email protected] ----- Original Message ----- > From: "Nate Burke" <[email protected]> > To: [email protected] > Sent: Monday, February 27, 2017 9:08:12 AM > Subject: Re: [AFMUG] AF24 and Edgepoint Slow Speed in 1 Direction > Flow control is disabled in both the Edgepoint and the 16SG. I found a > CCR1009 with an SFP+ Port I can put on the 16XG to test to the X86 10G > card. Other than the Tik on the other end of the AF24 link, I don't > have any other Tik's directly connected to this setup. > > On 2/26/2017 10:10 PM, Mitch Koep wrote: >> Flow Control?? >> >> >> On 02/26/2017 06:31 PM, Nate Burke wrote: >>> I have a setup which I just Installed, and I'm trying to track down >>> no speed in 1 direction on the link, Not having much luck so far, so >>> I thought I'd ask. The AF24 is reporting full modulation. I can't >>> even maintain a winbox connection to the router. >>> >>> RB1100X2 -> Copper to AF24 >>> AF24 -> Copper to Edgepoint S16 -> 10G fiber to Edgeswitch 16XG -> >>> 10G fiber to X86 Mikrotik with Dell KJYD8 Broadcom 10G card. >>> >>> The Mikrotik to AF24 path is on the default Vlan1 on the 16XG and >>> Edgepoint S16. >>> >>> Bandwidth Test results: >>> TCP BW test at 500mb+ from the RB1100X2 (cpu limit) to the X86 >>> ~2mb from the X86 to the RB1100X2. >>> >>> UDP BW Test at 700MB from the RB1100X2 to the X86 >>> X86 is transmitting 700mb, but the RB1100 is only receiving ~400mb >>> >>> MTU on everything is set to 1518. >>> >>> >>> Open to any ideas of what to try. >>>
