Whoa baby. Can you clone the MAC of the old AP?
------ Original Message ------
From: "Nate Burke" <[email protected]>
To: [email protected]
Sent: 4/10/2017 11:34:19 AM
Subject: Re: [AFMUG] overlap on ePMP sectors ?
Seperate SSID per sector, but not the Preferred AP scan list in the SM.
I got bit early on with that since it locks to the MAC of the AP,
changed a sectors after a storm and had to go visit all the SM's to
update the preferred AP List so they could link up again.
On 4/10/2017 10:30 AM, Adam Moffett wrote:
All on the same SSID? Or different SSID on each sector?
I think the preferred AP list is looked at in top down order. If the
top one goes away (reboot or whatever) I assume you move to a lower
one, but I don't see a rescan after x minutes option.
------ Original Message ------
From: "Josh Luthman" <[email protected]>
To: "[email protected]" <mailto:[email protected]> <[email protected]>
Sent: 4/10/2017 11:14:51 AM
Subject: Re: [AFMUG] overlap on ePMP sectors ?
ePMP doesn't automatically jump between sectors at all. I tested
this with 3.2 in the last few months. There are a bunch of customers
getting -75 from the south facing sector when east is -60. It's been
a good month on the wrong sector at this point. I expect a manual
rescan or reboot would fix it.
Josh Luthman
Office: 937-552-2340
Direct: 937-552-2343
1100 Wayne St
Suite 1337
Troy, OH 45373
On Mon, Apr 10, 2017 at 10:37 AM, Nate Burke <[email protected]>
wrote:
I normally deploy 4 120 sectors on a tower. ABAB frequency. No
issues observed Keep 5mhz guard between AB and you should be fine.
Almost all customers can see more than 1 sector. Just waiting for
automatic rescan in EPMP to automatically put them back on the
strongest sector after an AP Reboot.
On 4/10/2017 9:31 AM, Adam Moffett wrote:
Disclaimer: I haven't done it.
I'm thinking if you put a guard band between the adjacent sectors
you'll be fine. If the F/B ratio is comparable to the Cambium
sector antenna then you should be able to do F/B re-use. It takes
a pretty high F/B ratio though.
------ Original Message ------
From: "Paul McCall" < <mailto:[email protected]>[email protected]>
To: "[email protected]" <mailto:[email protected]> <[email protected]>
Sent: 4/10/2017 10:21:58 AM
Subject: [AFMUG] overlap on ePMP sectors ?
We have 3 KP Performance 120 degree sectors on a tower with ePMP.
It was the first tower we did with ePMP, and hindsight being 20/20
I would have done 40 90s to get the F/B Frequency reuse benefit.
If we add another 120 and make them all N S E W (4 total) I would
have about 30 degrees of overlap per sector. What is that going
to do with ePMP performance, if anything?
Paul
Paul McCall, President
PDMNet, Inc. / Florida Broadband, Inc.
658 Old Dixie Highway
Vero Beach, FL 32962
772-564-6800 <tel:%28772%29%20564-6800>
<mailto:[email protected]>[email protected]
<http://www.pdmnet.com>www.pdmnet.com
<http://www.floridabroadband.com>www.floridabroadband.com
