You used the Shireen Cat 6 heads?
Jerry Head wrote:
Regular crimpers worked for us on these heads.
On 6/12/2017 2:13 PM, Jay Weekley wrote:
We bought some ARC wireless Cat 6 connectors to go onto Shireen Cat 6
cable but they were a major pain to use. The wires had to be forced
in instead of sliding in with minimal effort. My idea now is to buy
Shireen Cat 6 connectors which hopefully will work better. Does
anyone know if these connectors require a special crimper or can we
use what we already have?
https://www.streakwave.com/itemdesc.asp?ic=CON-RJ45-C6-100&eq=&Tp=&o1=0
Jay Weekley wrote:
Cat 5 should be sufficient but one radio shares a tower with 2 FM
stations so we're having to do everything we can to mitigate
interference. The other problem is a mystery since it's on a
decommission water tank with no other radios than ours.
David Coudron wrote:
We are just starting to install a number of towers where we are
using Mimosa equipment and have run Cat6a for those where the
cabinets won't be on top of the tower. For the ones that are on
top of the tower we ordered pre-terminated cables. Just too much
hassle for the cost. For those where we had to run cable to the top
we ordered new quiktex ends since they use the regular old
crimpers. We couldn't find any ends to work with our Ez rj45
crimper. We will be terminating those cables the next few days.
We do have Mimosa equipment installed with Cat5e cable and it works
fine now. We initially had issues with the Ethernet ports dropping
and replaced POEs and were considering recabling. However fixing
the RF link interference issues and some firmware upgrades have
really stabilized those Ethernet ports now. We haven't had an
Ethernet port go down in 10 months since we did that work. (I am
currently knocking on wood. 🙂)
Get Outlook for iOS <https://aka.ms/o0ukef>
------------------------------------------------------------------------
*From:* Af <[email protected]> on behalf of Christopher Gray
<[email protected]>
*Sent:* Thursday, June 8, 2017 7:20:38 AM
*To:* [email protected]
*Subject:* Re: [AFMUG] Shielded Cat6 recommendation
I bought some Shireen Cat6 to try. The OD of the insulation on the
Shireen Cat6 (and other Cat6 cables I've found so far) make it
unusable with the EZ-RJ45 plugs. So, I ended up purchasing new
plugs, and should have purchased a new crimper.
I later asked here about using Cat6 with Mimosa and got a fairly
resounding "Cat5e is enough" at the time. In the end, it seemed
like a giant pain for any spot other than having great interference.
On Wed, Jun 7, 2017 at 10:24 AM, Jay Weekley
<[email protected] <mailto:[email protected]>> wrote:
We recently received a recommendation from Mimosa to replace our
shielded Cat 5 with Cat6. We've been using Shireen lately and
they have a Cat 6 product. What would you use? Has anyone had
problems with using Cat 5 with Mimosa?
<http://www.avg.com/email-signature?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=emailclient>
Virus-free. www.avg.com
<http://www.avg.com/email-signature?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=emailclient>
<#DAB4FAD8-2DD7-40BB-A1B8-4E2AA1F9FDF2>
---
This email has been checked for viruses by AVG.
http://www.avg.com
