probably a good candidate for armored as well. https://www.fs.com/products/40892.html
On Mon, Apr 30, 2018 at 2:40 PM, Bill Prince <[email protected]> wrote: > That's going to be tough. You have 4 more 90s than you want, so if there > is a way to break the run into multiple pulls is the only way you're going > to make it. Those junction boxes are going to make it very hard to > transition without exceeding the minimum bend radius. > > > bp > <part15sbs{at}gmail{dot}com> > > > On 4/30/2018 11:26 AM, Jay Weekley wrote: > > > <https://www.facebook.com/photo.php?fbid=993439894141736&set=gm.624613164555926&type=3&theater&ifg=1#>We > are providing a backup internet connection to a local bank and I need a > recommendation for a fiber run. We had conduit installed from our equipment > box on the top floor of a banks parking deck to an equipment room on the > first floor 4 stories down where it will be coupled with an existing run of > single mode fiber. There are 8 - 90 degree bends and at least 4 of those > won't be sweeping 90's since they had to make some of the transitions > from one direction to another with junction boxes. > > Also, at the top of the deck there is a 60 foot vertical section of > conduit that leads to the bottom of the deck and transitions 90 degrees > along the ceiling of the first floor. I need to find a way of securing the > cable (strain relief) to the junction box that is in the picture I am > including. Alternatively, I could use a recommendation for securing it to > our equipment box. Either way, I don't need the weight of the cable > damaging itself or tugging on our equipment in the box. > > We know how long the cable will be so we will be buying it pre-terminated. > > -- > *Jay Weekley* > > *Cyber Broadband * > > > -- -Louis NTInet O: 803-533-1660 X 207 C: 803-997-0004
