Hi,
Are there any simple instructions for using jhalfs ?
I've tried to build this with mixed results. Problems I've had include
- it took me a short while to work out the required build command,
including the location of the sources. Eventually I went with
./lfs -D /mnt -B 6.2 -G
-T 0 -M -W /usr/share/LFS-BOOK-6.3-XML
Is this right? Could the readme contain the command line to use,
perhaps in a "quick and dirty run-it-now" section ?
- I was getting an "error2" about a third of a way into the build
but I found out this was down to disk space - perhaps a disk space
requirement in the readme ?
- I am now getting an "error2" in the build of the kernel, however
I think I have plenty of disk space this time. I have checked the log
file from the Kernel build but I can't see anything obvious. I am using
a config file from my "by hand" LFS system.
Any thoughts on where I am going wrong, or pointers would be much
appreciated.
Thanks,
John
|
--
http://linuxfromscratch.org/mailman/listinfo/alfs-discuss
FAQ: http://www.linuxfromscratch.org/faq/
Unsubscribe: See the above information page
