To comment on the following update, log in, then open the issue:
http://www.openoffice.org/issues/show_bug.cgi?id=89233
User aw changed the following:
What |Old value |New value
================================================================================
Assigned to|aw |thb
--------------------------------------------------------------------------------
Status|STARTED |NEW
--------------------------------------------------------------------------------
------- Additional comments from [EMAIL PROTECTED] Tue May 13 13:12:06 +0000
2008 -------
AW->THB: Checked with DEV300 m11 basegfx. This is not an error at all. The
points in question are NOT equal, but are A(11076, 6441) and B(11076, 6440). You
can see that in full zoom and travelling over the edge points (in edge mode,
F8). This gives a short vertical line between the curve segment and the left
edge which is mitered - even when only a short line - correctly. When You move
one of the two point exactly onto the other (also possible in full zoom) all is
shown as expected and without the existing short edge. So this is not an error
at all.
---------------------------------------------------------------------
Please do not reply to this automatically generated notification from
Issue Tracker. Please log onto the website and enter your comments.
http://qa.openoffice.org/issue_handling/project_issues.html#notification
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
