Takashi, >the patch was already in cvs. but i'm not sure whether it was >already >fixed on rc2. please try the cvs version. >you'll need to update alsa-lib, too, if you use the cvs drivers.
I downloaded the cvs version and attempted the “cvscompile” in the driver, libs, tools and utils. Unfortunately I could not compile the lib because of an error. Seems to be occurring in the control/ control_shm.c file. I have attached the output for you to see. I am sorry I took so long to answer but my disk was full and I had to move some stuff around to be able to compile ok. I would like to confirm the following though: 1. All I need to do is a “cvscompile”, the modules will be automatically installed (no need to depmod –a for example?). 2. I need not remove the rc2 compilation output (no “make clean” necessary?) TIA, Hugo Ferreira. FROM: Takashi Iwai DATE: 08/07/2002 06:20:43 SUBJECT: RE: [Alsa-devel] Opti 931: Med931 ver.2.0 At Wed, 7 Aug 2002 13:52:19 +0100, <EMAIL: PROTECTED> wrote: > > Hi, > > 1. I am using kernel 2.4.8 (from Mandrake 8.1). In the ftp sight > I came across kernel patches. My question is do I have to apply these > patches? BTW, I only found patches for 2.4.7 and 2.4.9. Does this > mean 2.4.8 is not supported/tested or its ok. no, as long as you compile alsa-driver externally from alsa-driver package, you don't have to apply a patch to the kernel. > 2. I also found in the patches section a patch for the Opti 931 > chip. It was submitted on the 2002-05-07 by Michael Corlett and > assigned Jaroslav Kysela. Its status is still open. Does this mean > it still has not been applied to cvs or is not included in rc2 of > ver. 0.9.0? A simpleton� question: how is the �tatus�classified? the patch was already in cvs. but i'm not sure whether it was already fixed on rc2. please try the cvs version. you'll need to update alsa-lib, too, if you use the cvs drivers. > On a more general note, could someone out there that has the Opti > 931 working give me a hand on this? Specifically I would like to > know if the driver� pnp detection was on or if the isapnp tools > where used. Please note that I have successfully bused the OSS > drivers and am using the same settings with the ALSA drivers to no > avail. i could help for general fixes but such a hardware specific problem is difficult to handle without the card in hands... perhaps Massimo, the original author of opti9x drivers, can help better. (now cc'ed, too) Takashi ------------------------------------------------------- This sf.net email is sponsored by:ThinkGeek Welcome to geek heaven. http://thinkgeek.com/sf _______________________________________________ Alsa-devel mailing list <EMAIL: PROTECTED> https://lists.sourceforge.net/lists/listinfo/alsa-devel ------------------------------------------------------- This sf.net email is sponsored by:ThinkGeek Welcome to geek heaven. http://thinkgeek.com/sf _______________________________________________ Alsa-devel mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/alsa-devel
