Paul, Hi. Thanks for sendign these along. First steps look good. I've managed to patch things and it does install.
QUESTION - I am not explicitly loading snd-hammerfall-mem, but it is getting loaded when I start Alsa. Is this correct? I should _not_ explicitly load that file anywhere, but just let the driver load it? Also, I seem to have had some problems with the second patch you sent. It didn't apply. I'm sure it's just me. IT was so simple so I just typed it into the file. Were these sent as attachments, or as text within the email? Hopefully I'll get some sound later today. Currently nothing is hooked up to the card, so that will take a while to switch over as everything is quite buried right now. Thanks, Mark Wizard alsa-driver # lsmod Module Size Used by Not tainted snd-hdsp 32556 0 snd-rawmidi 15040 0 [snd-hdsp] snd-seq-device 4352 0 [snd-rawmidi] snd-pcm 64928 0 [snd-hdsp] snd-timer 15876 0 [snd-pcm] snd-page-alloc 5404 0 [snd-pcm] snd-hwdep 5216 0 [snd-hdsp] snd 32836 0 [snd-hdsp snd-rawmidi snd-seq-device snd-pcm snd-timer snd-hwdep] snd-hammerfall-mem 1920 0 [snd-hdsp] radeon 107972 1 agpgart 11920 3 (autoclean) ide-cd 27080 0 (autoclean) cdrom 25984 0 (autoclean) [ide-cd] Wizard alsa-driver # Wizard card0 # more hdsp RME HDSP 9652 (Card #1) Buffers: capture dee00000 playback df000000 IRQ: 17 Registers bus: 0x28800000 VM: 0xe08e6000 Control register: 0x100805e Status register: 0x2800000 Status2 register: 0xffff8701 FIFO status: 0 MIDI1 Output status: 0xffffff00 MIDI1 Input status: 0xffffff3a MIDI2 Output status: 0xffffff00 MIDI2 Input status: 0xffffff39 Buffer Size (Latency): 8192 samples (2 periods of 32768 bytes) Hardware pointer (frames): 0 Passthru: no Line out: on Firmware version: 1 Sample Clock Source: Internal 32 kHz Preferred Sync Reference: ADAT1 AutoSync Reference: None AutoSync Frequency: 0 System Clock Mode: Master System Clock Frequency: 32000 IEC958 input: Internal IEC958 output: Coaxial only IEC958 quality: Consumer IEC958 emphasis: off IEC958 NonAudio: off IEC958 sample rate: Error flag set ADAT1: No Lock ADAT2: No Lock ADAT3: No Lock SPDIF: No Lock Word Clock: No Lock ADAT Sync: No Lock Wizard card0 # On Fri, 2003-06-13 at 21:55, Paul Davis wrote: > this patch fixes some basic problems with the hdsp driver with respect > to the hdsp9652 card. it also cleans up a few minor issues with naming > in the driver, and slightly rationalizes initialization to involve > the minimum of special-casing for the hdsp9652. > ------------------------------------------------------- This SF.NET email is sponsored by: eBay Great deals on office technology -- on eBay now! Click here: http://adfarm.mediaplex.com/ad/ck/711-11697-6916-5 _______________________________________________ Alsa-devel mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/alsa-devel
