I had an interesting problem this weekend when launching. I would turn on
the TeleMetrum on the pad, open up the software on the computer, and get a
good signal and have no problem reading the telemetry from the board.
However, after a few minutes (5-10?) the computer appeared to quit
receiving  data (the age would start to climb). I would try to restart the
software, but when I went to monitor flight, it would show N0CALL in the
callsign window. I went out to the pad, and the TeleMetrum was still
beeping as it should, so I turned off the avionics, took down the rocket,
opened up the avbay, checked everything through the USB port (all seemed
OK), put it back on the pad, turned it on, started up the software, and
regained telemetry. However, after 5--10 min I again lost telemetry and
couldn't get it back. I went ahead and launched the rocket as I was flying
with a Raven 2 and using TeleMetrum deployment as backup, and I didn't
expect the flight to go OOS. It flew very well, data file downloaded post
flight showed that all events occurred as planned (all charges went off),
and it had an accurate GPS track as well. So aside from telemetry, all
appeared to be just fine. Unfortunately, I didn't have another
computer/dongle to see if that would receive signals from the rocket.

I have flown this rocket several times now, always with a Raven/TeleMetrum
combo, and it has worked splendidly everytime (except for the flight
before it was known to need the battery mod- all my batteries have
the protection circuit removed now). Never had any trouble receiving
before.  I haven't had a chance to test it at home yet. It was hot on
Saturday, but no hotter than the launchesd in June and July, both of which
were perfect.

Any thoughts on what is happening? I will update once I am able to do some
further tests at home (and get accurate time to loss-of-signal, if I can
duplicate the problem.

Regards,
David
_______________________________________________
altusmetrum mailing list
[email protected]
http://lists.gag.com/mailman/listinfo/altusmetrum

Reply via email to