Unfortunately no luck with that either. I'm going to try J-Link/J-Flash later next week unless anyone else has any suggestions.
-Jared On Fri, Jul 15, 2016 at 7:28 PM Keith Packard <[email protected]> wrote: > Jared Szechy <[email protected]> writes: > > > Is there some trick to getting the lpc11u14 to communicate over SWD? From > > reading the datasheet it looks like SWD is disabled under reset, so I > can't > > force it to communicate that way. > > I often have to hold the reset line low while starting the openocd > connection process for some reason. I think it has to do with openocd's > support for the STlink v2 programming protocol. It's not consistent at all. > > > Once I can get my EasyMini's to communicate again, I'll submit a patch > for > > the use of current OpenOCD for flashing. > > Thanks. > > -- > -keith >
_______________________________________________ altusmetrum mailing list [email protected] http://lists.gag.com/mailman/listinfo/altusmetrum
