Thanks Keith. Yeah, I didn’t see a big reason to update the stock firmware from the firmware that’s on it...I’m making a cable so I can load my TeleMini+GPS version of AltOS on it.
I’ll wire it up! -Bryan > On Mar 27, 2018, at 7:49 AM, Keith Packard <[email protected]> wrote > > Bryan Duke <[email protected]> writes: > >> I haven’t been able to find a definitive wiring diagram for updating >> firmware for the TeleMini v3. > > First off, there's no big need to update TeleMini firmware at this > point; the only fix relevant is to make the beeper sound when power-on > self-test fails. > >> Can I cut up a USB cable & connect the >> USB data+, data- and ground wires to the TeleMini v3 pins 1, 2 & 3? > > Yup. I have a cable wired up for this to do the device bring-up. > > On the connector: > > 1 USB D- > 2 USB D+ > 3 Ground <- square pad > 4 Reset > 5 SWD I/O > 6 SWD CLK > > It's wired like this so that I could use our "standard" debug connector > (four pins: clk, i/o, reset, gnd). But, having built a seven-pin > connector that does both debug and USB, it doesn't actually matter > anymore. > >> Sorry to be a pain - If this thing was cheap I’d just try it. I’m >> trying my best not to let the smoke out though. > > There's no power on that connector, so risks are fairly low. > > You can check the release notes in upcoming releases to see if there's a > critical fix for TeleMini; I always review all of the changes before > finishing up a release to make sure I don't miss one. > > -- > -keith _______________________________________________ altusmetrum mailing list [email protected] http://lists.gag.com/mailman/listinfo/altusmetrum
