Thanks Will. 😁👍❤️ I see these are 0.062.inch which is the same I found on Adafruit. But I'm still going to buy some from Bdale too. 😁
On Mon, Jul 12, 2021, 11:12 AM Will Marchant <[email protected]> wrote: > Bdale sells the appropriate SMA connector at > https://shop.gag.com/parts/sma-connector-pcb-edge.html and that page > also has part numbers for other vendors. > > On 7/12/21 11:01 AM, AlbyVA wrote: > > > > > > I think I found the solution, so somebody can correct me if I'm > mistaken. > > It looks like I can use an edge-launch SMA connector which would be > solder > > such that the 4 prongs are anchored/solder to those 4 pads and the > > connector pole > > is soldered into the exact same place as the previous whip antenna. Then > > I can connect > > an external antenna to the SMA connector. > > > > Screen Shot 2021-07-12 at 10.59.11 AM.png > > > > > > > > On Mon, Jul 12, 2021 at 9:23 AM AlbyVA <[email protected] > > <mailto:[email protected]>> wrote: > > > > > > > > I'm sure this isn't a new issue, but my standard wire antenna > > broke off from my Telemetum. I was wondering, the two pads opposite > > of the wire antenna appear to be where one could solder an antenna > > connector. So I was wondering: > > > > a) Can you solder a connector to either side of the board, since > > there are pads on both sides? > > > > b) What type of connector/antenna is recommended? > > > > Thanks, > > > > > > > > > > _______________________________________________ > > altusmetrum mailing list > > [email protected] > > http://lists.gag.com/mailman/listinfo/altusmetrum > > > > -- > Will Marchant, KW4WZ > [email protected] > http://www.spaceflightsoftware.com/will/ > _______________________________________________ > altusmetrum mailing list > [email protected] > http://lists.gag.com/mailman/listinfo/altusmetrum >
_______________________________________________ altusmetrum mailing list [email protected] http://lists.gag.com/mailman/listinfo/altusmetrum
