I wonder if someone can help me here?
I'm still tyring to get someone else's setup of amanda running and I
feel I'm nearly there. But I'm confused by this:
2 night's worth of dumps failed (because I hadn't the correct tape in)
and I put in the right tape and ran 'diskflush tape1'. This seemed to
work fine but the printout of the dump says:
Total size 0.0MB
Tape Used 29.2%
Compression Ratio --%
Filesystems dumped 0
It then goes on to list lots of Filesystems that I think were dumped.
I did the flush manually and it certainly wrote a lot to tape, and the
2 logs(amflush.1 and log.20010222.0) look ok. The end of the log says:
-----------------
SUCCESS taper hennion /dev/dsk/c0t0d0s3 20010222 1 [sec 0.059 kb 160 kps 2694.6
{wr: writers 5 rdwait 0.000 wrwait 0.038 filemark 0.018}]
INFO taper tape Tape1_125 kb 5956064 fm 146 [OK]
FINISH amflush date 20010222 time 4164.489
-----------------
Does the 5956064 represent the Kb written to tape?
I would like also to know how to control the printed output.
Thanks in advance,
Ross
--
Ross Macintyre
Heriot-Watt University
[EMAIL PROTECTED]
