> On Apr 26, 2001, Juergen Knott <[EMAIL PROTECTED]> wrote:
> > Hm.....with "mtx -f /dev/sg7 slot first" i haven't problems. The tape is
> > changed. Also "mtx -f /dev/sg7 info" have no problems.
>
> But /dev/sg7 is not the tape device, it's the changer device.
correct, the tape device is /dev/sg6
> It is /dev/nst0, the tape device, that is not working. Are you sure
> /dev/nst0 is what you're supposed to use to access the tape device
> associated with that changer?
Before i installed a new hard drive in the system (only scsi devices), the
changer device was /dev/sg6 and the tape device was /dev/sg5. The device
/dev/nst0 (no-rewinding device?) is set from the beginning and was working
fine. But after installing the new hard-drive, i have changed the /dev/sg5 to
/dev/sg6 and /dev/sg6 to /dev/sg7. The /dev/nst0 device is not changed in the
config.
I don't understand that "mtx -f /dev/sg6 info" works fine.
And when i have loaded a tape manually and start "amcheck Daily", the loaded
tape was unloaded and than comes the error messages in /tmp/amanda/*.debug
It is an input-/output error.
Do you need Log- or debugfiles from Amanda?
Which commands shall i'm typing for the correct debugfiles?
Bye Juergen
--
Dies ist eine Microsoft freie Mail!
