Hi, This is the third amanda installation i have been working on in the last 2 weeks so apology for all the problems i've been posting to the list.
I'm currently installing a system to backup our local LAN to a single LTO-1 drive so no changer config to worry about. I have configured amanda and done a few test runs and it seems to backup OK however i'm wanting to run an amtapetype to verify what capacity amanda thinks the tape drive is. When i run amtapetype i get the following $ amtapetype -e 100gig -f /dev/nst0 Writing 1024 Mbyte compresseable data: 47 sec Estimate phase 2...amtapetype: could not write any data in this pass: short write and there is nothing in the amanda.debug at all. Has anyone seen this before as i can label the tapes in this drive and write onto it? thanks Tom
