Hi, I have a machine that does a DMZ backup with a DDS4 autoloader on it. I now also need to use this machine to backup a single machine onto a AIT2 single drive.
I have installed the drive and it is recognised. dmesg says.. Vendor: SONY Model: SDX-500C Rev: 010c Type: Sequential-Access ANSI SCSI revision: 02 (scsi1:A:0): 40.000MB/s transfers (20.000MHz, offset 15, 16bit) Vendor: HP Model: C5713A Rev: H107 Type: Sequential-Access ANSI SCSI revision: 02 (scsi2:A:4): 40.000MB/s transfers (20.000MHz, offset 32, 16bit) Vendor: HP Model: C5713A Rev: H107 Type: Medium Changer ANSI SCSI revision: 02 st: Version 20020205, bufsize 32768, wrt 30720, max init. bufs 4, s/g segs 16 Attached scsi tape st0 at scsi1, channel 0, id 0, lun 0 Attached scsi tape st1 at scsi2, channel 0, id 4, lun 0 Attached scsi generic sg2 at scsi2, channel 0, id 4, lun 1, type 8 so i can see the changer, and both tape drives. I had my amanda.conf set to use /dev/nst0 for the tape drive in the changer - I presume i would also now need to use /dev/nst1. How can i tell which one to use for which? My changer does now not work and and changing it to user nst1 does not also work? thanks Tom
