Thanks Stefan, I do have iptables running on the client since it is my firewall machine. It is currently set to allow all connections from the internal network to the fw though. There is always a chance that I have mangled something there though :-). I will check out the article you cited below.
Monitoring the fw logs I see connections from the backup server to the fw on 10080 being accepted. However on the fw machine in the amanda sendbackup logs I see: sendbackup: try_socksize: send buffer size is 65536 sendbackup: time 0.001: stream_server: waiting for connection: 0.0.0.0.50084 sendbackup: time 0.001: stream_server: waiting for connection: 0.0.0.0.50085 sendbackup: time 0.001: stream_server: waiting for connection: 0.0.0.0.50086 sendbackup: time 0.006: waiting for connect on 50084, then 50085, then 50086 sendbackup: time 30.001: stream_accept: timeout after 30 seconds sendbackup: time 30.001: timeout on data port 50084 sendbackup: time 59.997: stream_accept: timeout after 30 seconds sendbackup: time 59.997: timeout on mesg port 50085 sendbackup: time 89.992: stream_accept: timeout after 30 seconds sendbackup: time 89.992: timeout on index port 50086 sendbackup: time 89.992: pid 16879 finish time Sat Feb 4 18:09:20 2006 Any suggestions? Thanks, Gordon -----Original Message----- From: Stefan G. Weichinger [mailto:[EMAIL PROTECTED] Sent: Saturday, February 04, 2006 2:28 PM To: [EMAIL PROTECTED] Subject: Re: First try at backing up other clients Gordon J. Mills III wrote: > I am having a problem backing up another host with my amanda server. > This is my first try at backing up another linux machine. These are > both debian machines. The tape server can backup itself just fine. I > installed amanda-common and amanda-client on the client machine. I > setup the amandahosts file. On the tape server I added the client to > the disklist, etc. If I run amcheck it gives no errors and says all > clients are fine. But when I run the backup (amdump) I get an error for the remote client. > > Here are the lines out of amdump.1: > dumper: stream_client: connect to 10.10.10.3.50037 failed: Connection > refused > driver: result time 69.587 from dumper0: TRY-AGAIN 00-00001 could not > connect to data port: Connection refused > > After that it tries again with the same result. Can someone please > point me in the right direction. I know its probably something stupid > but I cannot figure it out. > > Using vtapes, 2.4.5p1 Any firewall active on server and/or client? These issues are very often related to AMANDA's usage of high ports. I don't know how the maintainer of the Debian-AMANDA-pkgs has configured the software, but there are configure-options to choose the port-range AMANDA uses. Maybe read http://wiki.zmanda.com/index.php/Configuration_with_iptables for a start and look for any active firewalling rules. Stefan.
