How do I tell Amanda to use a specific network interface if 2 exist on
the system.
I think you define it in amanda.conf like:
define interface eth2 {
comment "1000 Mbps ethernet"
use 4000 kbps
}
then use it in disklist file, put eth2 at the end of each list you want it
to be used.
For instance I would like Amanda to only use the ce4 interface..
ce0: flags=1000843<UP,BROADCAST,RUNNING,MULTICAST,IPv4> mtu 1500 index 2
inet 10.20.1.181 netmask ffff0000 broadcast 10.20.255.255
ether 0:3:ba:9a:4f:6f
ce4: flags=1000843<UP,BROADCAST,RUNNING,MULTICAST,IPv4> mtu 1500 index 3
inet 172.23.1.73 netmask ffffff00 broadcast 172.23.1.255
ether 0:3:ba:9a:4f:6f
Thanks,
Anderson
===========================================
Yu Chen
Howard Hughes Medical Institute
Chemistry Building, Rm 182
University of Maryland at Baltimore County
1000 Hilltop Circle
Baltimore, MD 21250
phone: (410)455-1728 (primary)
(410)455-6347 (secondary)
fax: (410)455-1174
email: [EMAIL PROTECTED]
===========================================
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
