I wonder if someone can help me understand what Amanda's trying to tell me about last Friday's backup. I've been using Amanda for a few years and it runs like a charm, but I got this in the status email this morning:
For two out of about 30 DLEs I got: Server1 /dir/dir lev 1 FAILED [cannot read header: got 0 bytes instead of 32768] Server1 /dir/dir lev 1 was successfully retried Server2 /dir/dir lev 1 FAILED [cannot read header: got 0 bytes instead of 32768] Server2 /dir/dir lev 1 was successfully retried Then in the Notes section I got: taper: Will request retry of failed split part driver: Out of tapes; going into degraded mode And also: There are xxxxxxxxxxM of dumps left in the holding disk. I do full backups every night. The amount of data I back up equals only about 40% of a single tape's capacity, so the "out of tapes" message can't be true. Not sure at all what "cannot read header..." means. Would appreciate any advice on this. Johan
