Dustin,
Updated amanda.conf with
device_property "BLOCK_SIZE" "2 mbytes"
Tried to relabel a labeled but never used tape, priviously
Curie46, labeled with the default device_property (default
as in I hadn't specified anything).
I have to overwrite the tape header, there is a level below
the amanda label I have to get to ?
Device is an LTO4 imbedded in an SL24 library fiber connected
to a x4500 Solaris 10x86 box.
> amlabel -f curie Curie47 slot 23
labeling tape in slot 23 (/dev/rmt/0n):
Reading label...
Found an empty tape.
Writing label Curie47..
amlabel: Error writing label: Error writing tapestart header: I/O error.
thank you,
Brian
On Fri, Mar 05, 2010 at 05:54:40PM -0600, Dustin Mitchell wrote:
> On Mar 5, 2010, at 12:25 PM, Brian Cuttler <[email protected]> wrote:
>
> >Is the advice not valid for our config ?
> >Do we need to re-label tapes if we set this parameter ?
>
> The advice is valid, but yes you will need to relabel the tapes.
>
> Dustin
---
Brian R Cuttler [email protected]
Computer Systems Support (v) 518 486-1697
Wadsworth Center (f) 518 473-6384
NYS Department of Health Help Desk 518 473-0773
IMPORTANT NOTICE: This e-mail and any attachments may contain
confidential or sensitive information which is, or may be, legally
privileged or otherwise protected by law from further disclosure. It
is intended only for the addressee. If you received this in error or
from someone who was not authorized to send it to you, please do not
distribute, copy or use it or any attachments. Please notify the
sender immediately by reply e-mail and delete this from your
system. Thank you for your cooperation.
