On Sun, Jun 30, 2019 at 21:49:16 -0400, Gene Heskett wrote:
> On Sunday 30 June 2019 19:40:19 Nathan Stratton Treadway wrote:
> > amrecover> sethost picnc
> > 200 Dump host set to picnc.
> > amrecover> setdisk /
> > 200 Disk set to /.
> > amrecover> setdate --06-08
> > 200 Working date set to 2019-06-08.
> > amrecover> cd /home/pi/linuxcnc
> > /home/pi/linuxcnc
>
> failed here, no pi to be found.
In the transcript you posted in your message on Mon, 24 Jun 2019
15:03:35 -0400, you show a sucessful "cd /home/pi", so if it didn't work
this time perhaps you didn't set the host to picnc?
(I came up with the path "/home/pi/linuxcnc" based your dd/tar-based
recovery instructions in a later email, so that could be a bit wrong,
but you should at least be able to "cd /home/pi" and then use "ls" to
figured out what to "cd" into below that.)
Nathan
----------------------------------------------------------------------------
Nathan Stratton Treadway - [email protected] - Mid-Atlantic region
Ray Ontko & Co. - Software consulting services - http://www.ontko.com/
GPG Key: http://www.ontko.com/~nathanst/gpg_key.txt ID: 1023D/ECFB6239
Key fingerprint = 6AD8 485E 20B9 5C71 231C 0C32 15F3 ADCD ECFB 6239
