I am experiencing graphics problems on AlmaLinux 9 using the integrated graphics of an AMD Ryzen 9 7950X.
Last known good: Linux 6.18.56 First known bad: Linux 6.18.58 Still affected: Linux 6.18.63 The symptoms vary between affected versions: I first noticed a hard lockup when I powered off my Windows 11 kvm session where graphics are rendered to a dedicated Nvidia RTX 5080. So the first suspect was either the Nvidia hardware or kvm/qemu. Later the problem got worse and I was unable to boot into run level 5 where my onboard AMD graphics for my Ryzen 9 7950X gets activated. At some point it appeared my system even needed a cold boot to get in a usable state as there were hardware errors unrelated to the graphics at booted that prevented the boot to continue that disappeared after a complete power off. I think this was with 6.18.59 and 6.18.60 but not completely sure. Currently with 6.18.63 the problem is: hard lockup when I power off my Windows 11 kvm/qemu session with the RTX 5080 in passthrough mode and hard lockup when I end my Gnome session in Linux that uses the onboard AMD graphics, so my primary suspect is the amd driver. Because of the hard lockups nothing gets logged, but I’m sure there are ways around that. Steps to reproduce: Boot into run level 5 on AMD graphics Reboot Lockup I currently use 6.18.56, which does not exhibit the problem. These kernels are built using rpmbuild from unmodified upstream sources, without additional source patches. The RPM spec is based on ELRepo's spec, with local changes for Secure Boot signing. Secure Boot is enabled. I haven’t changed the kernel config or firmware in between. My setup is: AlmaLinux 9 A custom build 6.18 kernel with secure boot but without patches or other modifications I have kernel modules via dkms for: zfs, nvidia and anbox. However the nvidia modules are currently completely disabled at boot. System has 128GB RAM, a Ryzen 9 7950X and Nvidia RTX 5080. On the Linux side I run the standard Gnome that comes with AlmaLinux 9: 40 on the onboard graphics for the 7950X and at the same time Windows 11 via kvm/qemu on the RTX 5080. Willing to provide further details if required or perform further debugging. #regzbot introduced: v6.18.56..v6.18.58 Kind regards, Jeroen Beerstra
