Hi, Also find the problem. In my program I use buffers: to create an array. Never thought that these will be cleared at a reset, and also the variables used in my program . After make an init and start this after a reset my application is working as it should.
Cheers, Jan > Op 12 nov. 2018, om 19:30 heeft Jan Kromhout <krom1...@hotmail.com> het > volgende geschreven: > > Hi, > > After a few days of trial and error, I finally managed to control the 12c-LCD > mine. > A stupid interpretation caused the delay, eventually solved. > My tests are running well. > > But now it comes. When I give a reset of the Arduino and afterwards I want to > write a value to the LCD then it simply does not work. > After reset I init the I2C again. When I check with $38 i2c.ping? I get back > the true (-1) value. The i2c.status is $f8, but I can’f fint the > meaning of this value. > > When I check the I2C bus with logic analyser no activity. > > Only when I re-load the application it does run again. > > > Any idea what that could cause? > > Cheers, > > Jan > > > > _______________________________________________ > Amforth-devel mailing list for http://amforth.sf.net/ > Amforth-devel@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/amforth-devel _______________________________________________ Amforth-devel mailing list for http://amforth.sf.net/ Amforth-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/amforth-devel
