Re: [amibroker] COM/OLE question

[Tomasz Janeczko]

It does not matter where you apply this - it will cause nesting anyway (you are causing formula execution inside the very same formula - so it nests over and over again), so it is clear it should be run from the outside. Best regards, Tomasz Janeczko amibroker.com ----- Original Message ----- From: Steve Dugas To: amibroker@yahoogroups.com Sent: Sunday, May 21, 2006 7:50 PM Subject: Re: [amibroker] COM/OLE question But it happens in all modes, including even syntax-checker in the editor....   Do I need to create a .js file and run it outside AB as Dingo has suggested?   Steve ----- Original Message ----- From: Tomasz Janeczko To: amibroker@yahoogroups.com Sent: Sunday, May 21, 2006 1:24 PM Subject: Re: [amibroker] COM/OLE question You must not call AA.Optimize while you are in optimize mode. You are creating indirect loop that way: you press "Optimize" button -> AmiBroker calls optimization then your formula calls optimization and again optimization and again and again and again.....infinite nesting.   BTW: it is not necessary to use jscript anymore as AFL has full OLE support. Best regards, Tomasz Janeczko amibroker.com ----- Original Message ----- From: Steve Dugas To: Yahoo - AmiBroker Sent: Sunday, May 21, 2006 6:33 PM Subject: [amibroker] COM/OLE question Hi All - I wonder if someone who is good with COM/OLE interface could take a look at the small code below and see if there is anything wrong? I am trying to call the individual optimizer via COM/OLE, and I am getting the Amibroker error message  "Can not create that many optimization variables", but I am only using one optimization variable. Can anyone see some problem with the code that is causing this? Thanks very much! Steve   // enable an AFL scripting host EnableScript( "jscript" ); // AFL code pds = Optimize( "Periods", 6, 3, 9, 3 ); Buy = Cover = Cross( Close, MA( Close, pds ) ); Sell = Short = Cross( MA( Close, pds ), Close ); // begin script <% // create AmiBroker object AB = new ActiveXObject( "Broker.Application" ); // retrieve analysis object AA = AB.Analysis; // set which tickers to run on AA.ApplyTo = 1; // 1=current ticker // set range AA.RangeN = 15; // last 15 quotes // set range type AA.RangeMode = 1; // 1=n last quotes // select which module to run AA.Optimize( 1 ); // 1=individual // report results AA.Report( "" ); // display report if "path/filename" is empty string // end script %> Please note that this group is for discussion between users only. To get support from AmiBroker please send an e-mail directly to SUPPORT {at} amibroker.com For other support material please check also: http://www.amibroker.com/support.html SPONSORED LINKS Investment management software Real estate investment software Investment property software Software support Real estate investment analysis software Investment software YAHOO! GROUPS LINKS  Visit your group "amibroker" on the web.    To unsubscribe from this group, send an email to:  [EMAIL PROTECTED]    Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.