Hi Graham, Thanks a lot. I'll try to code it.
Robert - In [email protected], Graham <[EMAIL PROTECTED]> wrote: > > make one condition a cross and the other condition higher than the other > > > -- > Cheers > Graham > AB-Write >< Professional AFL Writing Service > Yes, I write AFL code to your requirements > http://www.aflwriting.com > > On 02/01/07, cstdc5588 <[EMAIL PROTECTED]> wrote: > > > > Hi All, > > > > I have written a simple program. When MACD and Signal cross over, > > while MA20 and MA50 cross over, and their directions are the same, > > the system gives the signal for buying or selling. Showed as > > following: > > > > Cond = Cross( MA(Close, 20), MA(Close, 50) ); > > Cond1 = Cross( MA(Close, 50), MA(Close, 20) ); > > Cond2 = Cross(MACD(12, 26), Signal(12, 26, 9)); > > Cond3 = Cross(Signal(12, 26, 9), MACD(12, 26)); > > Buy = Cond AND Cond2; > > Sell = Cond1 AND Cond3; > > > > For example: on the 1st day MA20 and MA50 cross over, on the 2nd day > > MACD and Signal cross over, and their directions are the same, at > > this point the system gives the signal for buying or selling. > > > > For another example: on the 1st day MACD and Signal cross over, on > > the 2nd day MA20 and MA50 cross over, and their directions are the > > same, at this point the system gives the signal for buying or selling. > > > > How to revise the above program in order to satisfy the conditions? > > Any help would be appreciated! > > > > Thanks, > > Robert > > > > > > > > Please note that this group is for discussion between users only. > > > > To get support from AmiBroker please send an e-mail directly to > > SUPPORT {at} amibroker.com > > > > For NEW RELEASE ANNOUNCEMENTS and other news always check DEVLOG: > > http://www.amibroker.com/devlog/ > > > > For other support material please check also: > > http://www.amibroker.com/support.html > > > > Yahoo! Groups Links > > > > > > > > >
