Ken,

Equity without any parameters uses LAST BACKTEST settings (including the range),
so if his settings are for example 1 last bar - then the backtest will be 
performed on last one bar only.

Instruct your friend to adjust settings in AA window (and run backtest).

Alternativelly provide PARAMETERS to Equity() to override analysis range. 
http://www.amibroker.com/f?equity

And no, you don't need to run backtest everyday.

Best regards,
Tomasz Janeczko
amibroker.com
  ----- Original Message ----- 
  From: Ken Close 
  To: [email protected] 
  Sent: Monday, March 26, 2007 8:45 PM
  Subject: [amibroker] Equity() Command


  I understood the Equity() command to act as a builtin Backtest.

  Accoringly, I create the following simple code to create and plot the Equity.

  E5    =  EMA(C,5);

  E45   =  EMA(C,45);

   

  Buy   =  Cross(E5,E45);

  Sell  =  Cross(E45,E5);

  PlotShapes(Buy*shapeUpArrow,colorGreen);

  PlotShapes(Sell*shapeDownArrow,colorRed);

  Eq    =  Equity();

   

  Plot(Eq,"Equity",colorBlue,styleLine);


  I loaded this into the Indicator Bulder, and applied it and got my Equity 
plot.  No other steps required.

  I shared the code with a friend.  He did the same thing, applied it, and got 
an {Empty} array and no plot.
  He loaded the code into the AA window, clicked Backtest, and the plot of 
Equity appeared.

  Question:  why did the same code act differently?  Next, will it be necessary 
to run the backtest every day to update the Equity curve?

  Insights and suggestions will be appreciated.

  Thanks,

  Ken


   

Reply via email to