Thanks, Ron I'm EOD and I'll give this a try.
Ed --- In [email protected], "Ron Rowland" <[EMAIL PROTECTED]> wrote: > > Ed, > > To use RotationalTrading in "Production Mode" do the following: > > 1) Enable "Add artifical bar (allows to see tomorrow's trades)" which > is in the Portfolio section of the AA backtester settings > > 2) Run backtest > > 3) Examine trade list > > If you are running with EOD data and 1-day trade delays, then any new > trade generated as of 5/13/08 close will be displayed as new buy for > 5/14/08. The position to sell will be a few lines higher in the > trade list, depending on number of holdings you have. > > > --- In [email protected], "Ed Hoopes" <reefbreak_sd@> > wrote: > > > > I have finished testing an ETF trading method that uses the > > EnableRotationalTrading() feature of AmiBroker. > > > > I would like to start trading it, but have been unable to find out > how > > to routinely get buy/sell signals. > > > > In other words, I want to switch the code from developmental/back > > testing into "Production Mode" > > > > I have looked in the HELP section, and in the UKB & KB on the AB > > website and haven't found anything. > > > > I would like to have an Exploration (or ???) that would show > > 1. Yesterdays portfolio > > 2. Today's portfolio. > > > > However I'm flexible on how the buys/sells would presented. > > > > Finally, I'm fairly good at AFL programming, so if someone could > give > > me a code fragment - that would get me going. > > > > > > Thank You, > > > > Ed Hoopes > > ReefBreak_SD@ > > > > PS. I know how to do this with ordinary BUY/SELL/SHORT/COVER > signals, > > but those are disabled in rotational mode. > > >
