i actally put 5 sec in the aa analysis frequency and it runs every 5 sec on a 1 minute db. i was trying .25 and it did not work. but if i put 5 sec. it works.
--- In [email protected], "Barry Scarborough" <[EMAIL PROTECTED]> wrote: > > AA will only allow you to use the most granular time period of your > data base. You will have to create a database with a shorter period > to get AA to allow you to use that period. I have a 5 second data > base, a minute data base, and an EOD data base. I cannot do AA using > 5 seconds when I have the 1 minute data base open. That period does > not show in the AA settings. I have to change to the 5 second > database and then the 5 second setting appears. Hope this helps. > > Barry > > --- In [email protected], "murthysuresh" <money@> wrote: > > > > what do u enter for 5 seconds. i believe that the AA analysis takes > > the frequency in whole minutes only. see screenshot. if i am wrong, > > pl tell me how do u enter fractional minutes. > > http://screencast.com/t/bblxS9p5E > > > > > > --- In [email protected], "Barry Scarborough" <razzbarry@> > > wrote: > > > > > > That is incorrect. I have 5 second data from IB and I set the > back > > > tester to run at 5 seconds and the trade times were on 5 second > > > boundaries. I am using AB 4.90.5. > > > > > > Barry > > > > > > --- In [email protected], "murthysuresh" <money@> wrote: > > > > > > > > the least frequency that the Auto Analysis runs is 1 minute. i > > tried > > > > changing it to .25 or .5 and it does not work. given the fact > > that it > > > > does not give me a error for fraction, i am not sure if its a > bug > > > that > > > > it does not run less than a minute frequency. > > > > > > > > > >
