Thanks Esteban I will try it out. Appreciate you sharing .... Larry
--- In [email protected], Esteban <[EMAIL PROTECTED]> wrote: > > Here it is Larry. Sorry I didn't check in with the group over the weekend, > thus the delay. > > BuyCnd=some code to establish buy to use in loop; > SellCnd=some code to establish sell to use in loop; > ShortCnd=some code to establish short to use in loop; > CoverCnd=some code to establish cover to use in loop; > > lpos=0; spos=0; > for( i = 26; i < BarCount; i++ ) > { > //Long side evaluation > if(BuyCnd[i] AND lpos[i-1]==0) //original buy sig > { > Buy[i]=1; > lpos[i]=1; > } > if(lpos[i-1]) //continue long > { > lpos[i]=1; > } > if(SellCnd[i] AND lpos[i] AND Buy[i-1]==0) > { > Sell[i]=1; > lpos[i]=0; > } > //short side evaluation > if(ShortCnd[i] AND spos[i-1]==0) //original short sig > { > Short[i]=1; > spos[i]=1; > } > if(spos[i-1]) //continue short > { > spos[i]=1; > } > if(CoverCnd[i] AND spos[i] AND Short[i-1]==0) > { > Cover[i]=1; > spos[i]=0; > } > } > > > One note. The first bar becomes a buy and I don't know why. I set i to 26 to > start on barcount 26 rather than to 1 trying to avoid this. Doesn't have an > effect. > > Hope the code helps you > > > > On Sat, Nov 15, 2008 at 9:18 AM, onelkm <[EMAIL PROTECTED]> wrote: > > > Esteban > > Would you please post your code, I have the same issue and have not > > gotten a loop to work. > > Thanks > > Larry > > --- In [email protected] <amibroker% 40yahoogroups.com>, "Esteban" > > <EstebanUno@> wrote: > > > > > > Thanks. I was able to model what I want using a For loop like you > > > suggested. It was easier than I thought it would be ... I was > > hesitant > > > to even try. The nice thing is that you can do all the array > > processing > > > you can before the loop, and then use the arrays in the loop. This > > kept > > > the loop simple and targeted to my specific problem. > > > > > > It still runs quite fast, but there's only one loop. > > > > > > --- In [email protected] <amibroker% 40yahoogroups.com>, "Steve > > Davis" <_sdavis@> wrote: > > > > > > > > This kind of problem can be solved by writing a for loop and > > setting > > > > the buy/sell signals one bar at a time. You will have complete > > control > > > > over the signals, but it will run somewhat slower. > > > > > > > > -Steve > > > > > > > > > >
