Thank you all. I found that I would need to set active project configuration to debug in order to use the debugger.
It is a small modification of ODBC from amibroker's website. As I am using stored procedures as the interface to the db, I need to modify it a little. Regarding the ODBC plugin, whenever I start AmiBroker, it asks me to select data source. Any idea on preventing it? Thank you again. Tomasz Janeczko wrote: > > > Hello, > > If you are using Visal C++ as your debugger you can simply, > pick "Broker.exe" as "Debug executable" in the project settings and > then you > just use run it within DEBUGGER. You can setup a breakpoint > inside for example GetQuotes function or anywhere else. > The debugging plugin does not differ at all from debugging any > other DLL in the VC. > > Best regards, > Tomasz Janeczko > amibroker.com > ----- Original Message ----- > From: "Ray Lee" <[email protected] <mailto:rlee835%40gmail.com>> > To: <[email protected] <mailto:amibroker%40yahoogroups.com>> > Sent: Thursday, August 06, 2009 12:26 PM > Subject: [amibroker] Debugging dlls > > > Hello, > > > > I am starting out writing a data plug-in. I am not sure what is the > > appropriate way to debug the plug-in in conjunction with AmiBroker. Any > > suggestion is welcome. Thank you. > > > > rlee > > > > > > ------------------------------------ > > > > **** IMPORTANT PLEASE READ **** > > This group is for the discussion between users only. > > This is *NOT* technical support channel. > > > > TO GET TECHNICAL SUPPORT send an e-mail directly to > > SUPPORT {at} amibroker.com > > > > TO SUBMIT SUGGESTIONS please use FEEDBACK CENTER at > > http://www.amibroker.com/feedback/ <http://www.amibroker.com/feedback/> > > (submissions sent via other channels won't be considered) > > > > For NEW RELEASE ANNOUNCEMENTS and other news always check DEVLOG: > > http://www.amibroker.com/devlog/ <http://www.amibroker.com/devlog/> > > > > Yahoo! Groups Links > > > > > > > >
