Hi - If you want to step through the array bar-by-bar, you should be using subscripts inside the loop that refer to the bar, e.g.
MCAD[i] But unless you need the loop for something else, I think you could just remove the looping code at the top and use your regular array-based AFL to do what you want... Steve ----- Original Message ----- From: "Michael" <[email protected]> To: <[email protected]> Sent: Wednesday, October 07, 2009 12:08 PM Subject: [amibroker] Need help - "for" loop MACD() not incrementing in array > Thanks for lookin'. > I am attempting to process a for loop through EOD data that includes a > test of the difference between the MACD() and Signal(). I installed a > trace and found that the MACD() and Signal() are not incrementing through > the data array. The numbers returned remain the same and I go nowhere. > > What do I have to do to increment MACD() and Signal() through the EOD data > within a for loop? > > Partial code sample follows: > > for(i = 1; i < BarCount; i++ ) > { // for loop bracket > x = MACD(); > y = Signal(); > Hist = x - y; > z = Hist > Ref(Hist, -1); // z = 0 if True, 1 if False > _TRACE("x =" + x +" y =" + y +" Hist =" + Hist); > > Thanks, > Mike L. > > > > ------------------------------------ > > **** IMPORTANT PLEASE READ **** > This group is for the discussion between users only. > This is *NOT* technical support channel. > > TO GET TECHNICAL SUPPORT send an e-mail directly to > SUPPORT {at} amibroker.com > > TO SUBMIT SUGGESTIONS please use FEEDBACK CENTER at > http://www.amibroker.com/feedback/ > (submissions sent via other channels won't be considered) > > For NEW RELEASE ANNOUNCEMENTS and other news always check DEVLOG: > http://www.amibroker.com/devlog/ > > Yahoo! Groups Links > > > >
