Did you write to support ? Please write to support in order to analyse problem you are having as this list is not support channel. When writing to support describe the steps required to reproduce problem. Reproducing problem on our end is essential to help you.
Before you do, please make sure that you have created the database PRECISELY in the way shown in the video: http://www.amibroker.com/video/IQFeed.html Each setting should be IDENTICALLY set as in the video and you must NOT exceed your subscription limit (with normal subscription it means 500 symbols maximum in your database). Your previous messages suggest that you have 6300 symbols in your database and that is totally over the top when it comes with IQFeed and *will* create problems. You should reduce the number of symbols in your database TO THE LIMIT of your IQFeed subscription (either 500 (normal subscription) or 1300 symbols - if your subscription allows that many). Best regards, Tomasz Janeczko amibroker.com ----- Original Message ----- From: "trfy1120" <[email protected]> To: <[email protected]> Sent: Saturday, October 31, 2009 4:10 PM Subject: [amibroker] Re: IQFEED AMIBROKER PROBLEMS >I went back to 5.20. The same problem exists. The duplicate data issue is >apparently not a function of the software being BETA. > > MS > > --- In [email protected], "Tomasz Janeczko" <gro...@...> wrote: >> >> Hello, >> >> If you were using ANY ALPHA 5.27 or 5.28/5.29 BETA prior to 5.29.2 you >> should CREATE NEW DATABASE >> from scratch. 5.29.0 for example had timestamp problem that could lead to >> duplicate if Quote Editor was used >> and that was fixed in 5.29.2 but once data with >> incorrect timestamps is saved it stays there. >> >> I can not stress it enough that BETA is BETA. >> >> If you want stability use official version 5.20. >> >> Best regards, >> Tomasz Janeczko >> amibroker.com >> ----- Original Message ----- >> From: "trfy1120" <trfy1...@...> >> To: <[email protected]> >> Sent: Friday, October 30, 2009 6:27 PM >> Subject: [amibroker] Re: IQFEED AMIBROKER PROBLEMS >> >> >> >I may not understand the question, but I use Amibroker for analysis not >> >trading. I don't think I am streaming symbols >> >simultaneously. I think Amibroker just downloads the data for each symbol >> >in the database sequentially so the IQFEED limit on >> >streaming symbols is, I think, not relevant in this circumstance. My time >> >frame of analysis ranges from a few months to one >> >day. >> > >> > MS >> > --- In [email protected], "Rob" <sidhartha70@> wrote: >> >> >> >> Can you specify how many bars you have in your DB...? What is the base >> >> time frame...? How many symbols are you streaming...? >> >> >> >> --- In [email protected], "trfy1120" <trfy1120@> wrote: >> >> > >> >> > >> >> > I just installed version 4.4.0.3 of the iqfeed client over the newer >> >> > version that I was using (4.6.1.0). Now I get a prompt >> >> > to >> >> > install the newer version every time I load an IQFEED database but, >> >> > after trying to duplicate my problem 4 or 5 times, I >> >> > have >> >> > been unable to do so. The data seem to be ok now. >> >> > >> >> > I am going to test some more tomorrow and, if the older program does, >> >> > in fact, resolve the problem, I will probably call >> >> > IQFEED >> >> > tomorrow. >> >> > >> >> > MS >> >> > >> >> > --- In [email protected], "trfy1120" <trfy1120@> wrote: >> >> > > >> >> > > Is anyone else having problems with IQFEED and Amibroker? In my >> >> > > case, I have had trouble with duplicate data. That is, >> >> > > for >> >> > > example, my database will have data for 10/29 preceded by data from >> >> > > 10/28 and then more data for 10/29. You can only see >> >> > > this when you look at the quote editor. It don't think it shows up >> >> > > in the charts but it does affect formula computations >> >> > > referring to previous bars. >> >> > > >> >> > > Today, my system is dropping data that were previously in the >> >> > > database. >> >> > > >> >> > > I think I am following the video database tutorial and I have >> >> > > contacted support without much luck. Does anyone else have >> >> > > any >> >> > > idea what may be going on? >> >> > > >> >> > > By the way, I use IQFEED to feed other programs so I don't think it >> >> > > is an IQFEED problem. >> >> > > >> >> > > Thank you, >> >> > > >> >> > > MS >> >> > > >> >> > >> >> >> > >> > >> > >> > >> > ------------------------------------ >> > >> > **** IMPORTANT PLEASE READ **** >> > This group is for the discussion between users only. >> > This is *NOT* technical support channel. >> > >> > TO GET TECHNICAL SUPPORT send an e-mail directly to >> > SUPPORT {at} amibroker.com >> > >> > TO SUBMIT SUGGESTIONS please use FEEDBACK CENTER at >> > http://www.amibroker.com/feedback/ >> > (submissions sent via other channels won't be considered) >> > >> > For NEW RELEASE ANNOUNCEMENTS and other news always check DEVLOG: >> > http://www.amibroker.com/devlog/ >> > >> > Yahoo! Groups Links >> > >> > >> > >> > > > > > ------------------------------------ > > **** IMPORTANT PLEASE READ **** > This group is for the discussion between users only. > This is *NOT* technical support channel. > > TO GET TECHNICAL SUPPORT send an e-mail directly to > SUPPORT {at} amibroker.com > > TO SUBMIT SUGGESTIONS please use FEEDBACK CENTER at > http://www.amibroker.com/feedback/ > (submissions sent via other channels won't be considered) > > For NEW RELEASE ANNOUNCEMENTS and other news always check DEVLOG: > http://www.amibroker.com/devlog/ > > Yahoo! Groups Links > > >
