List: I've done some more tinkering with application of the below (very simple) code. I am using IB's data feed. What I've discovered is that, if I take my exploration and double-click it to launch it as a "chart," the values are reported properly to the Trace window, RT.
If I run the exporation from the Automatic Analysis window, it reports the RT values of the Close properly, however, the values of the moving average are always reported as 0. Does anyone have an idea of why this is happening? (This is actually a major problem for me, since I want to run the Exploration every few seconds on a list of tickers, not just one....) Thx. GB. ________________________________ From: Gray Bohon <[email protected]> To: [email protected] Sent: Mon, December 14, 2009 2:24:54 PM Subject: Problems with tracing variable value through exploration... I am doing some testing with explorations. I'm trying to get what seems like a very simple exploration to work, and its not doing what I would have expected. Here is my code: // Test the MA crossover exploration... // long trades entry and exit rules:MovAvg = EMA( Close, 15);BuySell Filter=Buy OR Sell; = = Cross( Close, MovAvg );Cross( MovAvg, Close );AddColumn ( Close, "Close");_TRACE("sell..."+ Sell+ " buy..."+ Buy);_TRACE("Close..."+ C);_TRACE I have the exploration set to run every 30 sec, on a chart that has 1-minute bars. There are plenty of signals that should be triggered by the data. For some reason, the variable "MovAvg" is reported in the trace-log the when I initially run the exploration, but registers a value 0 on subsequent itterations as it autoruns. I think I must be missing a setting or something. Attached is my autorun setup. Any ideas on why this is happening? The value of the Close is reported accurately by every itteration of the autorun. The values of Buy and Sell are also reported, though I think is not working right based on the problem with "MovAvg." Thanks in advance. -GB("MovAvg..."+ MovAvg);
