No, I ran Explore many, many times. I ran it manually a few dozen
times. And also set "Run every" at different intervals, 1, 2, and
5minutes. With "Run every" set, I could observe, new times and prices
displayed in AA spread sheet for all other symbols. In the IB status
box, lower right corner of AB, I saw message suggesting the I check
symbology once. That is why I tried the other symbols. I'm using
ib.dll 2.0.2, AB 5.26, and TWS 901.8.
Perhaps someone who uses IB for data, can try COCO for me?
If someone using IQfeed could NOT get COCO, that would be interesting
(or a coincidence).
Thanks for your response,
-- Keith
On 6/1/2010 16:05, Herman wrote:
Did you run the explore just once?
Nw symbols that on the first pass do not have any data yet will NOT be
included in the report. For example, if I Explore 500 new tickers in a
new database less than half will be listed, the others did not have
any data yet. When this happens I just run the explore again, on the
same list, and then all tickers will be there.
This only happens during the first pass for new symbols.
herman
> I entered 11 stocks into one of my AB watch lists. For most of the
> 11, this was the first day for them to be in my IB data base. I
> started an explore. But only 10 of the eleven were listed. The
> eleven stocks were: ATPG, AUXL, CM, COCO, DV, HOS, LOPE, NE, OII,
> SMTC, TTEC. The one that was not list by Explore was COCO. The
> only condition for being listed is:
> Filter = inWatchList(1), and COCO is indeed in the watchlist with
the other 10.
> The .afl for running Explore also plots prices for stocks. It
> worked for all but COCO. I even entered COCO on the API tab in the
> TWS trading platform. TWS plotted a 1min chart for COCO just fine.
> And BTW, the Explore displayed the Last Close and Time of Last Close
> throughout the day and both were kept right up to date, with "Run
every" set for 2min.
> I have also tried entering COCO-STK, COCO-NASDAQ, and
> COCO-NASDAQ-STK. But that didn't help.
> Does anyone have any idea what might be going on here?
> Any suggestions on how I might go about debugging this problem?
> Thanks for any help coming my way,
> -- Keith
> ------------------------------------
> **** IMPORTANT PLEASE READ ****
> This group is for the discussion between users only.
> This is *NOT* technical support channel.
> TO GET TECHNICAL SUPPORT send an e-mail directly to
> SUPPORT {at} amibroker.com
> TO SUBMIT SUGGESTIONS please use FEEDBACK CENTER at
> http://www.amibroker.com/feedback/
> (submissions sent via other channels won't be considered)
> For NEW RELEASE ANNOUNCEMENTS and other news always check DEVLOG:
> http://www.amibroker.com/devlog/
> Yahoo! Groups Links
