In a message dated 6/2/03 10:06:44 PM, [EMAIL PROTECTED] writes:
> Would someone be willing to share the pinout of the Amphenol > barrel connector and voltage requirements? > Joe, Pinout as follows: 1 - NC 2 - B+ in (225 V.) 3 - B+ in to the screen grids of the RF, mixer and 1st IF stages. This came from the xmitter and was the means by which the receiver was muted during transmit. 4 - NC 5 - +12 V. to heaters. AC OK here. 6 - Gnd. 7 - NC 9 - Audio out (600 ohms) 8 & 12 jumpered together 10 & 11 " " Pins 10/11 and 8/12 connected to the "Power" switch on the front panel of the receiver. Used to turn the various power supplies for the receiver and transmitter on and off. Hope this helps. Dennis D. W7QHO Glendale, CA --- StripMime Report -- processed MIME parts --- multipart/alternative text/plain (text body -- kept) text/html The reason this message is shown is because the post was in HTML or had an attachment. Attachments are not allowed. To learn how to post in Plain-Text go to: http://www.expita.com/nomime.html ---
