Rick,
I beleive you said that the knob was Off the shaft.
If so, screwing it IN further might be easier to get it free.
Also placing the knob on a shaft and heating the shaft
might help.
Most allen/spline, and torx screws are hard steel where the tool opening
cracks apart and digs in, jamming. Near impossible to drill. Straight blade
setscrews seem to usually be softer steel and the head flares out. Easier to
drill.
But with one out, maybe that is all you need to refasten it.
Good Luck,
Bill
KB3DKS/1
______________________________________________________________
AMRadio mailing list
List Rules (must read!): http://w5ami.net/amradiofaq.html
List Home: http://mailman.qth.net/mailman/listinfo/amradio
Partner Website: http://www.amfone.net
Help: http://mailman.qth.net/mmfaq.html
Post: mailto:[email protected]
To unsubscribe, send an email to [EMAIL PROTECTED] with
the word unsubscribe in the message body.
